[Set Escape Location]

 

Function

·This command sets a location that can be escaped to using escape skills and items.

 

Settings

 

·Locations can be set as follows.

 

1.Click the [...] button to open the [Escape location] window (see below).

 

2.Click to choose the map/area containing the desired location from the list on the left side of the window.

3.From the map/area shown on the right side of the window, click to select the position, then click the [OK] button. The map zoom level changes when [1/1], [1/2] or [1/4] is clicked.

4.If [Switch to turn ON after escaping] is enabled, a specific switch will be turned ON when the player escapes to the location specified in 3. The switch to be used can be selected from the [Switches] window which can be opened by clicking the [...] button.

 

Notes

·Only one location can be set as an escape location. If an escape location has already been set before this command is used to set another escape location, the previous one will be removed.

·The escape function is similar to the “Teleport” function, but by changing the ability to use either depending on the map, it is possible to make a distinction between the two.

·For example, “Teleport” can be disabled in a dungeon, but “Escape” can be enabled instead to return to the entrance.